
Hard water leaves minerals that settle at the bottom of the tank. Over time that layer makes the burner work harder, makes noise and shortens the tank’s life.
1
Listen for the warning signs
Popping or rumbling while the heater runs usually means sediment is boiling under the water.
2
Turn off the power or gas
Set a gas control to Pilot, or switch off the breaker for an electric heater, before you start.
3
Drain a few gallons
Attach a hose to the drain valve, run it to a floor drain or outside and let the water run until it comes out clear.
4
Refill before you relight
Close the drain valve and open a hot faucet until water flows steadily. Only then turn the heat back on.
5
Mark the date
Write it on the tank. Once a year is right for most homes, more often with very hard water.
Leave it to us if…
The drain valve is plastic, stuck or already dripping.
The tank is over 10 years old and has never been flushed.
You see rust in the water or around the base.
You aren’t comfortable relighting a gas pilot.
A yearly flush is included in the Protection Plan, along with a full inspection of the heater.
Still leaking?
A plumber can be there today.
Same-day service on most calls. 24/7 for emergencies.
Protection Plan
A yearly checkup catches this early.
From $15 a month
24/7
Open 24/7
Help is
one call away.
Same-day service across Your City, priced before any work starts.
